Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing.
by Arielto » Fri May 27, 2022 11:49 am
Hi,
I am replacing the triple clamp on my 2021 250rr and need to carry over the bearings from the existing triple clamp.
The bearing on the lower tripple clamp sits very tight around the axle and am not sure what would be the way to remove it without causing any damage.
Your help and recommendations is greatly appreciated.
Thank you!
Ariel
- Attachments
-
- bearing2.jpg (35.77 KiB) Viewed 2361 times
-
Arielto
-
- Posts: 2
- Joined: Tue Jun 08, 2021 5:30 am
by F5 Dave » Fri May 27, 2022 10:34 pm
Buy a new set.. removal is destructive. I don't see a way of not distorting the cage without some tricky puller I've never seen . Usually this isn't a concern as you are replacing a buggered set.
21 XTrainer
-
F5 Dave
-
- Posts: 66
- Joined: Sat Oct 16, 2021 12:37 pm
- Location: New Zealand
by Darkside » Sun May 29, 2022 9:07 am
the only way I can think of is to press the stem out of the bearing and clamp together
Randy
2018 390 rrs, 2014 300 rr re, 2010 ktm 450 exc
-
Darkside
-
- Posts: 449
- Joined: Tue Jul 30, 2013 12:53 pm
- Location: SF Bay Area
Return to Chassis & Body
Who is online
Users browsing this forum: No registered users and 98 guests