Xtrainer 300 oil injection reservoir stayed full

[John Ventura]

After my xTrainer 300 third ride. I checked the oil injection reservoir after the 90km ride and it was still full. I decided to remove the oil reservoir and premix the oil with fuel. What issues my I encounter ?

[F5 Dave]

There's a kit to block it off properly, investigation of what it is would be a good idea.
Checking wiring to solenoid would be a good idea. And have read solenoid can get blocked but easy to clean.

[fenderworks]

are you saying the oil injection oil was full, then you rode 90km and it was still full? i dont think 90 km is enough to notice a injection oil level difference.
i probably would not see much oil used if i rode 90km on my xtrainer. i would notice it at about 200km.
Xtrainer uses very little oil, especially at low rpm.

this is my experience on my machine.

[John Ventura]

are you saying the oil injection oil was full, then you rode 90km and it was still full? i dont think 90 km is enough to notice a injection oil level difference.
i probably would not see much oil used if i rode 90km on my xtrainer. i would notice it at about 200km.
Xtrainer uses very little oil, especially at low rpm.

this is my experience on my machine.

on the first 200kms it emptied the oil injection tank. Then on the last ride with the oil tank filled it did not use any oil.

[fenderworks]

""on the first 200kms it emptied the oil injection tank. Then on the last ride with the oil tank filled it did not use any oil.""

ok....ya you should check it out to be safe. hope all goes well.