by Hyde » Tue Oct 14, 2014 3:47 pm
I've straightened a 4t and a 2t Beta radiator that where a little worse than that, for the twist put it in a vise with wood blocks and just twist it back by hand there quite easy to untwist.
The crushed part I loop safety wire around the side plate through the cores a few times to make a loop were it needs pulled, find two wood blocks 6"-8" and support the radiator on the ends, set it on the edge of your work bench and use a big C clamp through the safety wire loop you made and the other end under the work bench top, with the threaded part of the clamp hanging toward the floor, and start screwing the clamp tight, you may need to make a few loops and work your way slowly pulling the cores straight.
Those radiator seem soft, but the are pretty easy to fix, I'll try and take a photo of the blocks and wire, but you need to untwist them first.
23' 430RE
23' 250RE
21' 350RE
20', 200rr, gone
20', 250rr, Ye-haw !
18', 250rr,gone
18' 125rr, KYB forks, gone
16' 250rr, KYB forks-sold
15' 250rr RE-sold
14' 450rr, gone
14' 250rr-sold
14' 450rr KYB forks.